V3R SURFACE MOULD REMOVER 5LR / 15LR
Cleaning mould is simple and easy with SAN-AIR Surface Mould Remover. Removing any visible mould, it kills it at the root and ensuring that it stays gone! A ready made solution, you simply apply with a wipe away.
​
The SAN-AIR range effectively eliminates mould and bacteria at their source. What sets our product apart from other mould and bacteria killers is its long-lasting effects. Once the surface mould remover has been used to remove the mould, place a jar of Mould Gone in the room to keep it away. The gel continues to provide protection 24/7 against future growth - each jar lasting upto to 3 months, providing sustained and reliable protection to your environment.
Features:
-
Highly effective formula: SAN-AIR Surface Mould Remover Immediately removes visible mould
-
Independently tested and confirmed to remove 99.99% of Surface mould and Bacteria.
-
The SAN-AIR gel evaporates into the air effectively killing the bacteria at source
-
Long-lasting effects: SAN-AIR protects the cleaned surface for up to 12 months. Keeping you and your family safe from any mould or bacteria contamination.
-
Environmentally friendly: Made from natural ingredients that are safe for use around both people and pets. It contains no harsh chemicals or toxic substances.
-
Convenient to use: ready made solution that is wiped over affected area
-
Cost-effective: offers a cost-effective solution to bacteria growth, saving you time and money in the long run.
-
Surface Mould Remover thoroughly cleans any surface of mould without any toxic chemicals. Simply spray onto any surface leave 15 minutes then wipe away.​
-
Easy to use
-
100% safe for people, pets, property
-
No toxic chemicals
-
Biodegradable
-
Sustainable
-
Fast-acting
-
Neutralise toxic mould and mildew
-
Neutralise bacteria
-
Removes the root of the mould
-
Remove odours
-
Reduce your mould cleaning frequency
-
Reduce your environmental impact
INSTRUCTIONS FOR USE:
-
Set-Up
-
Adjust the nozzle to a fine spray, test the surface you want to clean by spraying a small area first.
(Note it is normal to see the surface lighter in colour while wet).
-
-
Clean
-
Spray to coat mould evenly, wait 15 minutes and wipe the mould off with a clean dry cloth.
-
Ensure that dirty clothes are not reused as you will spread the mould. Instead, for each wipe, use a clean area of the cloth until the cloth is used up, then continue cleaning with a new clean cloth.
-
Repeat step 2 until all mould has been removed.
-
-
Finish
-
Use a final spray with a fine mist and allow to air dry, leaving a fine mould prevention coating.
-